Thread: Hpi Pro 4
View Single Post
Old 09-04-2004, 10:08 AM
  #7369  
Super Steve
Tech Master
iTrader: (9)
 
Super Steve's Avatar
 
Join Date: Oct 2003
Location: Toronto, Ontario, Canada
Posts: 1,177
Trader Rating: 9 (100%+)
Default

Originally posted by Skill
The Pro 4 Jet knuckles are an extremely tight fit as regards to the bearing sizes, but they do go in.

The problem I had last night was that I broke the ball end which screws into the steering knuckle, and guess what, it broke clean off at the steering knuckle...so how am I supposed to get that out?

Other than that it was a good night, my PRP chassis was handling great and it was really quick round the sweepers...I wonder what it'd be like with a one-way in too
Ouch... that sucks

I would try slotting the stud and then screwing it out...
It will put a little groove on the knuckle, but it's better then no knuckle
Super Steve is offline  
Reply With Quote