View Single Post
Old 05-21-2012, 10:25 AM
 
AJSanDiego
Tech Initiate
iTrader: (3)
 
AJSanDiego's Avatar
 
Join Date: Jun 2011
Location: Escondido, Ca.
Posts: 40
Trader Rating: 3 (100%+)
Default

Originally Posted by chevtech23 View Post
Yes arm mount shims, FWD(forward) RWD(rearward) for that end of the car, you would run the same in the front forward and front rearward, and possibly different ones in FWD and RWD in the rear to adjust rear toe, along with a combination of offset and standard arm mounts.

I use these for the shims, Associated #3617
http://www.amainhobbies.com/product_...-Bulkhead-Shim

Hopefully this is a more helpful answer than "RTFM"
Thanks. And for the link too. I went ahead and went with my assumption. Went with the stock recommendations and except for RWD rear - put the 2* to start with (what I think is) 2* toe when combining the 0 offset rear arm mount and the shim. Should be dropping my electronics in today. Can't wait.
AJSanDiego is offline  
Reply With Quote