TESTING
Did a lot of testing this past week with the RSD6, had a chance to run on a high grip asphalt small track (100x60ft) and a large medium grip track (250x75ft).
Learned quite a bit on the track. I have made some changes from the baseline.
-Roll center is now at 0B in the rear.
-Removed the arm sweep
-I am using 4mm hexes with 0.5mm wheel hex spacers.
-14.5lb springs in the rear as well.
-removed 0.3mm of rear toe in (for 3.0 overall degrees)
I am still trying to get a little more steering in for our high speed decreasing radius corners at both tracks, however I am trying to figure out if it is more initial or mid corner traction that I am looking for. I'll keep testing and I'll report back.