Question
I've heard that a lot of people are putting orange o-rings between the reinforced lower arms in order to reduce slop. Where to you put them?
1) Do you put them on the screwhead side of the ballnut (MD-2 in the manual)? If so, will it restrict the down travel of the lower arm?
2) Do you put the o-ring on the chassis side of the ballnut? If so, will it restrict the up travel of the lower arm.?
I really do not want to restrict the range of the motion of the arms, but would like to get rid of some of the slop that you get after you install the reinforced arms.
Thanks in advance for your help.