Posted by Craig

Because you raised the outer (in your case the exact same amount), and you only wanted to lower the roll center, but keep the camber event pretty close to the same as before?

That's would be the same reason you grind down the chassis U on the B4.1 and run the C hub (except there you want to raise the roll center, which is why you lower the upper link).

Other than that, I have no idea what's going through your head on that one. I'd be interested to hear it (even if I disagree).[/QUOTE]




G-wiz,

you claimed you did your homework .....


Craig

Question I asked you is a real good one .

No one has questioned why Ae raised the stud so high and thought most here would have a interest in the reason ...



Giving Craig more time to find correct answer..