Originally Posted by
sffan15
All,
Sorry to bring up an old thread but I have an issue and hoping I can get some help.
I just got the GTB3, installed it in my xxx-sct with a castle mamba max pro. It binds fine, I've rebound it a couple times with what appears to be success (light goes from blinking to solid the second I turn the remote on (while holding bind button of course). Then, I plug the esc back into chan2 and servo into chan1, turn on the truck, and the red LED on the reciever blinks red very slowly. May e 2-3 seconds on, same time off, and repeats indefinently.
Any idea what could be going wrong? Truck/esc worked fine yesterday with stock Losi transmitter/reciever
Thanks!
You have to calibrate the esc to the new receiver. The procedure is in the Castle manual, it is something like turn on transmitter set everything on it to neutral (epa and dual rate 100%, trims at 0), hold full throttle, turn on ESC, it will beep some, wait, beep again, then push full reverse, wait for sceond set of beeps, then release to neutral, wait again.