Originally Posted by CraigMBA

I put a couple of hours of serious wrench time today, and I may no longer hate my SC10 4x4. It was pretty good the last time I had it out, but I didn't have the complete setup on it. (4mm Hot Racing hub risers, 3mm spacer). Now that I got the full jimmy, I gotta ask.

WTF! How does anyone run them this tall and not bend them into ribbons! That's an unreal amount of bending load! I think I'm going to fab up some spacers that will fill the void and allow me to screw into the other hole in the shock tower and take some of the dead load off of them. That is, unless anyone else has a better idea.