Originally Posted by
cla5675
Hey, guys. I just picked up a 1258TG servo for my FT SC10. I was testing the servo before installing it and I would get a "brown" out when the servo tunred to one side. Meaning the servo would stop turning and there would be a momentary power loss to the servo and receiver. I tried another receiver and the same thing would happen. Anyone else ran into this problem? I'm thinking I got a bad servo but want to be sure before I send it back to AMain Hobbies. Thanks!
Troy.
some times u can get glitching when your transmitter is too close to the reciever. if you try moving back from the car a bit and it still does it u need to make sure rx battery is a good battery and has enough charge in it to make sure.
if you have a fully charged battery and it is ok (not faulty battery) and you arnt too close and still does it then thats the last resort in being the servo at fault i guess.