R/C Tech Forums - View Single Post - Tamiya 1/12 R/C RM-01 "Racing Master"
Thread: Tamiya 1/12 R/C RM-01 "Racing Master"
View Single Post
Old 05-14-2012, 08:13 PM
  #572  
mdutcher
Tech Adept
iTrader: (8)
 
mdutcher's Avatar
 
Join Date: Dec 2011
Posts: 205
Trader Rating: 8 (100%+)
Default
Originally Posted by RedBullFiXX
PRS spur, but I'm pretty sure a Kimbrough will work fine too
http://www.tqrcracing.com/shop/produ...ord=78&pg_no=1

I recommend using Ceramic 1/8 diff balls
http://www.tqrcracing.com/shop/produ...yword=&pg_no=1
Ok, parts have been ordered and have arrived. I thought that I had the right size bearings that would work for this application, but I don't.

Can't use the stock bearings as there are 2 different sizes and then there is the step up on the shaft for the bigger of the 2 stock bearings.

Redbull, Can you provide me with the sizes of the bearings that you used? Any other tips and advice here would be greatly appreciated. I am so close to having this conversion done, I think.

Thanks for your help.
mdutcher is offline  
Reply