R/C Tech Forums - View Single Post - Houstons Engine Service H.E.S.
Thread: Houstons Engine Service H.E.S.
View Single Post
Old 05-14-2012 | 03:09 PM
  #6630  
houston's Avatar
houston
Tech Prophet
iTrader: (96)
 
Joined: Sep 2004
Posts: 15,844
From: Sherwood,OR
Default
Originally Posted by 1airborne
When you say ".6mm", are you talking about the gap between the throttle slide and the end of the opening? If this is the case how would you measure it?

Thanks
1airborne
ya bill the idle gap

where the ( of the slide barrel and the ) of the carb body meet to leave a gap

==()==
distance in there should be around .6mm
houston is offline  
Reply