R/C Tech Forums - View Single Post - Houstons Engine Service H.E.S.
Thread: Houstons Engine Service H.E.S.
View Single Post
Old 05-14-2012 | 01:57 PM
  #6629  
1airborne
Tech Regular
iTrader: (12)
 
Joined: Apr 2009
Posts: 424
From: Phoenix
Default
Originally Posted by houston
best thing to do on nova is warm it up , clear it out a few times , listen to the idle , if it revs high then comes down without being "tingy" its still rich (richen hsn before doing this) , lean lsn until comes down and stays consistent , then adjust idle gap until you get the desired idle , it usually ends up very close to .6mm but there are alot of determining factors
When you say ".6mm", are you talking about the gap between the throttle slide and the end of the opening? If this is the case how would you measure it?

Thanks
1airborne
1airborne is offline  
Reply