R/C Tech Forums - View Single Post - Throttle Servo Linkage - Is this correct ?
Thread: Throttle Servo Linkage - Is this correct ?
View Single Post
Old 05-13-2012, 08:03 PM
  #9  
meno1103
Tech Regular
iTrader: (6)
 
meno1103's Avatar
 
Join Date: Jun 2011
Posts: 422
Trader Rating: 6 (100%+)
Default
Originally Posted by deltrum
Yeah, fuel was blowing out of the pipe...I thought this was high speed needle was 3 turns out.

If I totally close the low-end needle and then set the servo linkage so that the carb is closed, how much should I open the low-end ?

The engine is a Force .28...the instructions are fairly basic and do not go into this level of tuning !
The linkage seems to be set up fine on the video. I would do as Kain suggested, start from factory settings on carb.
meno1103 is offline  
Reply