R/C Tech Forums - View Single Post - Throttle Servo Linkage - Is this correct ?
Old 05-12-2012, 01:09 PM
  #2  
Huleboer
Tech Adept
 
Huleboer's Avatar
 
Join Date: Feb 2011
Location: Horsens, Denmark
Posts: 217
Default

2mm!? Thats WAY too much!

When the servo is idle (when you're not pulling og pushing the throttle) the servo should push the carb all the way in, and then you set the engine idle with the idle screw.
Usually about .7mm gap.

And when on full throttle the carb should be fully opened.
Huleboer is offline