R/C Tech Forums - View Single Post - RC10T4.1 Thread.
Thread: RC10T4.1 Thread.
View Single Post
Old 05-11-2012 | 09:18 PM
  #1358  
microrcdude's Avatar
microrcdude
Tech Addict
iTrader: (70)
 
Joined: Jan 2004
Posts: 710
From: Portland, Oregon
Default
Originally Posted by chevmaro
My T4.1 keeps popping ballcups. They fall off real easy if i land wrong. Is this a common problem? I have other open wheel cars I race and dont have this same problem. I have tried AE cups with FT buckles and RPM cups with Lundsford buckles. What can I do here? I am lucky to make it through a race. Front seems fine its always in the rear.
When I got my kits, i noticed the ball studs still had manufacturing lube on them. I cleaned all of them with motor spray and put each in a drill, and spinning it while wiping it with a rag.

I also threw out the AE ball cups, they stretched way too quickly, and I have been using the RPM ball cups.
microrcdude is offline  
Reply