Any official photos of the production car can be found on
www.teamcorally.com or
www.corallyusa.com.
Droop screws.... we didn't want to go out too far from the chassis itself with the droop nubs on the chassis.
Lower Shock Positions.... the positions are not fixed. There are 3 holes on the arm with the extention adding a 4th outter hole. The extention is most likely going to be included in the kit.
Composite Knuckles.... right now it is sitting with composite knuckles in the kits.
Rear Hubs.... this was tested and compared in prototyping and we liked this better.
Diffs.... the belt tensioner is optional and included. Not needed as we have run several cars successfully without it. It also is not as high as the shock tower and made out of plastic. (the front). Yes the diffs are fixed and the center layshaft adjusts the belt tension.
Rear Mounts.... that deck will not flex to bother much. The photos posted earlier show incorrect rear shock tower, the assassin tower. The rear tower was redesigned then put on the front of the car.
Weight..... even with the rear mount extensions we are adding weight for rubber tire racing. We are expecting having to add weight on foam tire racing as well.