R/C Tech Forums - View Single Post - Go Engine USA 2011 Thread
Thread: Go Engine USA 2011 Thread
View Single Post
Old 05-09-2012 | 04:18 AM
  #2459  
Flanno's Avatar
Flanno
Tech Master
iTrader: (2)
 
Joined: Jun 2009
Posts: 1,566
From: Sydney
Default
Originally Posted by grizz1
Hi Guys,

Bit slow on the replies this week sorry. Flat out pumping more GXII's, G5T's and NZ Spec .25 truggy motors out into the marketplace. Crazy demand for GO here right now.

I have never seen a 2 x top oil hole GO rod. Perhaps the rod had been swapped out for another brand in that motor ?

I just quickly checked through the 40 odd 21-0600 Pro Series rods I have here (some old stock and some just arrived a few days ago), and they all have a single hole in the top groove directly above the top end bush, plus the normal bottom end hole at the end of the oil groove just above the big end bushing.
Out of curiosity I just checked mine too, and hadn't realy taken much notice before, and mine are the same as Grizz, one hole rite at the very top of the rod leeding into the top bushing for pudgen pin lube, and the usual one at the bottom of the groove down the length of the rod leeding into the bushing for crank pin lube.
Flanno is offline  
Reply