Originally Posted by
Bighomedog11
The friction pegs are flat on the spur gear now. They could be worn down because i havent changed them in a few months now. My clutch should be good because i just recently changed the clutch out..
And the one way bearing that is only effecting the pull-start correct? That is not effecting the slipping i am getting from the clutch? And what whats the best way to clean the one-way bearing
yea the one way bearing will only effect the pull start.The best way to clean it out is to take it apart and spray it down with some kind of degreaser and lightly oil it with some bearing oil. just make sure when you put it back in the text writing on the one side is facing the engine.