Hey Guys

I have been fighting a battle and loosing, until now

I am running 8 bolink eliminator with the following:

Note: I have 8 cars total
ESC :3 Castlewinder SV2 combo with Motor (4 Pole) it says 100,000 RPM MAX

ESC: 3 dynamite Fuze DYN3754

Receiver: 8 Futaba R203GF

Transmitter: 4 Futaba 3PRKA 2.4ghz

Battery: 6 - 7.4V 25C 5800mAH Lipo

Race Track: 1 Micro reality stock car racing size 24' X 24' X 24'


Problems I am having that I would like to address:

console #1 car # 1
ESC and MOTOR running hot after 10 or 15 min of running on 1 Castle
stops responding after a bit will go back and forth but with no steering after a while
Car going way too fast

Console 2 car 2

car glitching with lack of steering at times
car goes way to fast

Console 3 car 3
Car go way too fast
ESC and MOTOR running hot after 10 or 15 min of running on 1 Castle
No steering at all but steering
Steering dual rate when I turn it turns the wheel hard to one side

Console 4 car 4

Dynamite Fuse not responding at all only steering works but car does not go back and forth


and the other cars are only for backup.


1 problem I notice after going over manuals again is I did not calibrate transmitter with esc, I tried to follow the instructions, but no go.

Not sure how to go forward.

All parts a brand new and have only been installed and ran once thats when I discovered all of these problem.

Your help will greatly be appreciated

I am located in Kissimmee, Florida, if anyone is near and can assist me that would be great

Open to all ideas


Fuze Manual
.dynamiterc.com/ProdInfo/Files/DYN3740-Manual.pdf

Transmitter and Receiver Manual
//manuals.hobbico.com/fut/3prka-2_4ghz-manual.pdf

This is my current settings for Castle ESC
.castlecreations.com/support/documents/speed_and_gearing_chart.pdf

Castle manual
.castlecreations.com/support/documents/drivers_ed_guide.pdf




Pictures are here:


ps://plus.google.com/photos/108109637442162725515/albums/5736505701066308865?authkey=CPqAno6DtsCb1AE


Thanks so much in advance
Hot Rod