R/C Tech Forums - View Single Post - shiming motors
Thread: shiming motors
View Single Post
Old 08-29-2004, 01:18 PM
  #3  
raving-monkey
Tech Master
 
raving-monkey's Avatar
 
Join Date: Apr 2004
Location: yorkshire, england.
Posts: 1,818
Default
make sure you get the brushes in the centre of teh armature also..i have seena lot of peoples motors with the brushes right at the bottom (to many shims on teh bottom) or the brushes right at the top of the motor (to many shims at the top)
raving-monkey is offline  
Reply