Originally Posted by
Howler
I tried finding one like that as well, and ended up building my own.
-5mm flashing led
-1 servo wire extension
- scrap piece of 3/8ths acrylic
Solder the wire to the led, shape acrylic to fit in the slot of the wing, drill out acrylic for LED, insert led to acrylic block, wedge into wing, route wire to receiver. I used my vinyl cutter to produce a piece of vinyl with the grid of multiple holes for the light to shine through. Done. I should add that this was done for under $7.00.
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
If I can't get a piece of acrylic would maybe a clear piece of scrap lexan might work just as good?