Originally Posted by Jaz240

Well I started break in today. I had to heat it to almost 300 degrees to get it to tun over but my carb got so hot I was vaporizing the fuel

Got the heat more concentrated on the sleeve and managed to fire it up at about 260 degrees. Ran 1 tank on the ground in slow figure 8's at same steady low RPM's just to get some fuel through it and seat the bearings. ran through the whole tank with no hiccups.

Let it cool down and re-filled for tank 2 and got about halfway through it when my throttle servo died..I must have heated that to 300 degrees also


installing new servo now and will continue break in tuesday. Hoping to get about 10 tanks through it by Saturday and then race it Saturday night. I went with the Nova 9901 pipe to start with