Originally Posted by
TY@TEAMTEKIN
It would be helpful to wire up a brushless motor to it, set it for brushless and see if it runs. If it does, something else is going on. I can only do so much over a forum with troubleshooting.
Do you get any power up chimes at all?
I do not wish to De-Solder it now and swap it to Brushless, as I have had a few Beer's.
I do get a Chime Yes!
Now to get to the start of it all, Why did the Cap blow in the first place?
It was installed with the blue moon to the Negative Battery side, as per Pic.
Also when I had installed this, and connected the Battery, The Cap was already a warm to rather hot stage.
Then Calibration to BaNg ! and the smell.
Rather nice - not.
So Do I need another Number to send this back in?
Or Can I get a Refund?