the Be (electric version) has ALL the updated parts.. no need to get the V2 parts, the kit already has them all..

as for the build itself... one big word of advise...

CLEAN EVERYTHING WITH MOTOR SPRAY .. or brake cleaner

there is an oil residue on ALL parts, so clean them first, them start normal assembly using threadlock when needed.

One big issue with 1/8 is that anything and everything comes loose, so if in doubt, LOCKTITE IT!

- use grease on screws going into plastic, makes easier to assemble.
- use threadlock on setscrews that go into plastic.
- dont over tighten the sway bar ball mounts on the a-arms, it causes binding when moving the suspension arms.
- follow the instructions EXACTLY... yes the drivetrain will be tight, it loosens up as it breaks in.
- get some springs and sway bars as extra tuning options.
- CA your drive axle boots on, fill them with grease first.
- DONT put your transponder UNDER the esc, put it on the steering servo, or the RX box.
- ENJOY!