I had the same issue with my B5 and the engine screws. All I did was dremmel down one side of each screw, being careful not to dremmel into the hex hole on the top of the screw. It worked great.
Chad
Originally Posted by
beenaround
It was just me not seating the engine right. Now im having an issue getting the front screws in. I cant get them past the engines logo puffing out the side. Almost like I need shorter screws. Its the last thing I need to get the thing in order for break in.
Im also hoping ive built it correctly. When I was talking about getting the throttle setup installed I meant getting it seated in the engine and then screwing the little "seal tube" together in the back of it. I figured it all out from just sitting and looking at it and other engines online. But im still a little worried.