Originally Posted by
SuperRC
I just changed my B4 (not B4.1) setup from training to inline axle as I was experiencing way too much push when exiting corners unless i slowed right down, which really effects lap times. The inline axle setup is much better in and out of corners, however i am finding it quite unstable on the straights.
Does anyone have any suggestions on what I can change to get more control/stability on the straight with the inline axle setup?
Also, on a different issue. I seem to keep stripping the inner small ballbearings (3977) in my rear 0.5 aluminium hub carriers. They are wearing out on the inner side. I clean and lube then (as with all my bearings) very often. Has anyone had this same issue? Any suggestions how I can stop these bearings from wearing out so quickly?
see my car has a ton of steering initially, at the right speed, but on exit it pushes unless i really control my speed, i went to the trailing and the car was god awful. My car is fairly stable in the straight, it just seems more reactive than it used to be
as far as your bearing, is it possible you have smacked the back wheels against the tube/wall, it is very commong for the smaller bearings to break apart from crashes.