Originally Posted by SuperRC

I just changed my B4 (not B4.1) setup from training to inline axle as I was experiencing way too much push when exiting corners unless i slowed right down, which really effects lap times. The inline axle setup is much better in and out of corners, however i am finding it quite unstable on the straights.



Does anyone have any suggestions on what I can change to get more control/stability on the straight with the inline axle setup?



Also, on a different issue. I seem to keep stripping the inner small ballbearings (3977) in my rear 0.5 aluminium hub carriers. They are wearing out on the inner side. I clean and lube then (as with all my bearings) very often. Has anyone had this same issue? Any suggestions how I can stop these bearings from wearing out so quickly?