Originally Posted by
jirish617
hey guys, so i know there was some debate about trailing vs inline axles +8 chassis, and i didnt have enough time to try any of the suggestions anyone made for my lack of on power steering except for trying to go back to trailing axles, the steering became FAR WORSE. I literally couldnt go more than half throttle because the cars front ends handled like it was on ice. I had to go back to the inline axles. So, i just thought id give you all a headsup about that
I just changed my B4 (not B4.1) setup from training to inline axle as I was experiencing way too much push when exiting corners unless i slowed right down, which really effects lap times. The inline axle setup is much better in and out of corners, however i am finding it quite unstable on the straights.
Does anyone have any suggestions on what I can change to get more control/stability on the straight with the inline axle setup?
Also, on a different issue. I seem to keep stripping the inner small ballbearings (3977) in my rear 0.5 aluminium hub carriers. They are wearing out on the inner side. I clean and lube then (as with all my bearings) very often. Has anyone had this same issue? Any suggestions how I can stop these bearings from wearing out so quickly?