Originally posted by TryHard
I think if I remember rightly I'm using a shock length of 61 mm, I have slightly unwound the end caps to get this length and it seems to work fine. I can have a pretty much full range of droop.
However I notice your not running any spacers under the rear suspension toe brace. this could be causing the problem.
As I mentioned above, I'm using the Marc Rheinard setup for carpet and he didn't have spacers under the rear blocks. But I did try it before removing the spacers and it was the same.
Actually correction, just measured it, and I can't get lower than 4mm too, guess I'll have to extend the shock lengths, by undoing the ball studs a little. Actually I've put the rear shock at 63mm now, allows 3mm on the droop gauge, so it sits on 4mm with the droop screw resistricting it.
I hope this doesn't mean that there is a possibility of pulling out the shock rod from the ball adjuster
Thanks for the info, Ed.
Mark.