R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 04-09-2012 | 03:43 PM
  #13537  
goin2drt
Tech Elite
iTrader: (77)
 
Joined: Jun 2010
Posts: 2,167
From: Southern California
Default
Originally Posted by one4rose
Im not sure if its to tight or to loose. I put a piece of paper in between them and then tighten the screws. Im planing on buying a 81T spur gear and a 48P 19T pinion see if that helps. Right now trying to run a 16T pinion. Is the 19T a bigger gear? Size wise?
As long as the pitch is the same it doesn't matter. I run way more motor and do not strip the spur unless mesh is bad
goin2drt is offline  
Reply