Originally Posted by jayrat

Hey guys, I posted this once already but didn't see it so I'll post again.
MMP 1410 4Pole, savox 1256tg, sr300. Trying to center my servo and sr300 is glitching. I had the resolution set at 5.5ms and the receiver was blinking randomly as well as the motor would spool on its own. For troubleshooting I installed a non digital Hitec servo and bumped the resolution up to 16.5ms and everything was fine. What am I missing here? I don't think I should need a bec for one servo should I? any help would be greatly appreciated.

Jay.