R/C Tech Forums - View Single Post - Revolve RC Workstation?
Thread
:
Revolve RC Workstation?
View Single Post
04-02-2012, 09:50 PM
#
29
ufoDziner
Tech Master
iTrader: (
39
)
Join Date: Oct 2011
Location: Henderson, NV
Posts: 1,293
Trader Rating
: 39 (100%
+
)
Well... I got mine today. It is REALLY a quality setup. The spring clips clamp the chassis down tight enough that it won't move at all. That being said, my 8yo can easily lift them and remove the car. The quality of the pivot assembly is beyond what I expected. It is very smooth and easy to use. The one negative I see is with regards to the non-spring, or stationary pegs. They have a sort of cam on them which I used to precisely fit my chassis, which is awesome. Trouble is I have 3 different chassis. It's easy enough to space the pegs to work for all 3 with only a small tweak of the stationary pegs, again... awesome. However, they don't pivot easily. They require a hex driver to be adjusted. IMO something like a long thumbscrew would be an easier/better setup for adjusting for multiple vehicles. I've attached a few pics of it with my DEX410 and a T4.1.
Reply
ufoDziner
View Public Profile
Find More Posts by ufoDziner
View iTrader Profile