Originally Posted by
fq06
Im curious about the current setting, does that just limit the current on the bottom end uo to some preset motor rpm?
Or does it limit currentthroughout the entire rpm range?
Tekins explanation is a little vague.
Haven't mess with it yet, so just wondering.
that means im only using 85% full throttle. Would be the same if I had my RX8's hotwire settings were set at 100% current limiter and my controller throttle EPA set at fwd 85% instead of 100%. Need to take the laptop to the track and see what higher numbers would do. Truck wicked fast the way it is.
I dont think the tenshock is roar approved. But most local small tracks dont follow roar rules to the T.