Originally Posted by
beidle99
Tanks 3 and 4 were finished today...almost an hour of running time on the motor that I have done. This thing is super efficient. Still running in the 210* to 220* range. Towards the middle of the 4th tank I started rolling the throttle close to 75% and then backing off. The idle is staying consistent and I am getting good smoke, especially in the upper part of the throttle when I get the lsn out of the spray bar. Is tank 6 to early to start rolling to full throttle? When should I start to lean the HSN a little at a time? Its been a loooooong time since i broke in a motor.
its all good just dont let it get up on the pipe yet , it does have a bench break in so you give her a little bit to get the feel
of the mosheen
if it is running good and consistent , leave it for the time being , if it is an absolute pig lean it down just a little at a time but i would suggest keepin it in that temp range for a bit
