Originally Posted by fishboy

So I just picked up a TEN-SCTE roller and I am ready to buy electronics. Only problem is I having a hard time deciding on a motor. Here's the situation...

I run 2wd open short course trucks and 2wd mod truck currently and both have Tekin RS. So, I have a bunch of 2S 5000mAh 50C LiPo's.

So, to utilize my LiPo's and the Hotwire, I am planning to get a Tekin RX8 ESC and run 2S LiPo's in the truck.

I am looking at the Tekin Pro4 4600kV or the Tekin SC4X 4.5 turn. I've done some research and most things I've read said the Pro4 is the better choice for low end torque. I run on an indoor clay track that is roughly 130' X 80'.

I'm looking for your guys input and first-hand knowledge of the two. If someone has had both and can tell me a little about then and give your opinion that would be great.

Thanks,
Greg