R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 03-25-2012 | 05:59 PM
  #19992  
PastaBoyNY's Avatar
PastaBoyNY
Tech Master
iTrader: (1)
 
Joined: May 2011
Posts: 1,337
From: Queens NY
Default Aluminum Brace is the way to go.
Originally Posted by RossNZ
For the guys running the stick pack down the middle of the chassis, how's the chassis flex after taking out the rear chassis section? Does the CF rod mod cover this without excess flex? Thanks.
I am running my battery pack centered and broke two CF braces....all my own fault of course (grin). Today I went with an Aluminum Knitting Needle (thanks Slotmachine for the idea) and 8-32 threaded rod. The Needle was already Blue and it was the 8.5mm size. Weds will tell me the results. Also, I decided to use a fastener from the inside above the motor to hold the brace. I put a Nylock topside, then a Steel Hat Bushing, a washer or tow and another Nylock.

Sal
PastaBoyNY is offline  
Reply