my carriers (youre right, not arm) i just replaced the bushings in, and those bushings were 1/4" ID. does that mean the part with the threads that the rim bolts on to is 3/16"? im confused as to what makes the axles 3/16".
either way, the rpm carriers that came WITH the car (obviously not installed) were a set of rear arms with carriers, and the carriers had a set of flanged 1/4" ID flanged bearings. with the flanged bearings in either carrier, stock or rpm, there isnt enough clearance to get the roll pin back in.
simply put, if you were going to install CVDs on my setup, how would you do it? what parts would you replace and with what?