Originally Posted by
J-PaP
Hi I have a bit of an odd problem with my ezrun 13t combo. I have two of them and they both have the same issue. I moved them both into different cars and both cog and won't run after the initial throttle range setup.
Any help/advice would be appreciated. I'm using a spektrum receiver and 4200mah 40c lipo. Have tested it with a 5800mah 50c lipo as well and had the same issue.
Were they ever in working order? Are both combos new and if so, what happens if you try giving the motor a spin start by hand while giving it low throttle? If it can stay spinning and go from mid to high rpm after giving it a spin start, it means that all three phases are not operating properly. If this is the case, check all connections (including solder joints) from esc to motor.