R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 03-13-2012 | 06:27 PM
  #12730  
aeRayls's Avatar
aeRayls
Tech Elite
iTrader: (3)
 
Joined: Nov 2007
Posts: 2,257
Default

.

I fully agree with everything you posted. Most times a lot of guys get too caught up in setups and just need to reset/rebuild and just drive!!!

However while I normally would roll my eyes at someone using 5 limiters... There's atleast one team setup with just that. It also greatly depends on if you're using the inside or outside hole on the front arm!

If I'm usig a setup based off of using the outside(most typical) I will usually run 3 limiters. Now if I'm using inside I'll definitely start with 4. This past weekend I used 5 for the first time. It's not typical but it has it's uses. Now if this guy has 5 limiters and using the outside hole on the arm... Yeah not gonna be workin too good.
aeRayls is offline