R/C Tech Forums - View Single Post - Serpent 811E Buggy Thread
View Single Post
Old 03-12-2012 | 05:23 PM
  #1714  
bronc4now's Avatar
bronc4now
Tech Master
iTrader: (43)
 
Joined: May 2011
Posts: 1,475
From: Hoffman Estates,IL
Default

Originally Posted by porkchop
take all that stuff back apart deppen. and shim like the book my car would not move when i build 5 packs later it was dialed.

the serpent ring and pinnons need to be shimed tight and once they break in you never touch them.

and dont give me the you know this and that i telling you hard facts after 2 years

i build 4 buggy 10 truggys 4 ebuggy shim like the book say and forget about it.
o man i just re shimmed and it feels good i took the diff apart and put .3 shim on the cup side and 0 shim on the crown gear side ..but now you have me worried ill just go back to the book setup not sure . i guess if the case stretches out it might happen but the mesh between them now is good
bronc4now is offline