Hey guys I just got a HW 150a esc I updated the firmware to the newversion and put it in my sc10 4x4 with a cc 3800 and turnigy nano tech 5100 saddle packs and using a Flysky GT3B TX.

However now I have 2 issues:
First it doesnt seem like the brakes are working. The drag brake kicks in but that seems to be the only brakes I have.
Settings:
Forward and Brake only
Rev set at 100%
Drag at 60%
Initial breaking at drag

I have tried it with For/Brake/Rev setting also.

2nd issue is I have a ton of servo lag. When I hit the throttle and turn at the same time it lags badly, and the more throttle I give it the worst it becomes. Right now at its worst its about a sec of lag when I give it full throttle from a dead stop. It even does it when there is no load on the truck (upside down). My servo is a Hitec 5645MG.

I haven't had either one of these problems until I changed escs, CC MMM and Sidewinder. I have tried putting a capacitor on the 3rd channel (16v 4700uf) to help a glitching issue like I had to with my sidewinder and it didnt help.

Thanks for the help.