Originally Posted by
Jason Turner
Exactly right on the fronts - its a no go.
For rear ASC 7497 is actually correct width for B4.1 the ones you listed for the SC10RS are actually a little wider.
For rear wheels any B4, 22 , or RB5 wheels will work even losi branded some wrenches might not fit in there, but my Losi nut driver worked fine
My FT AE Nut Driver (11/32, green handle) fits into the TLR 22 wheel just fine. I recently switched from the standard wheel nut to the JC serrated nuts, they work like a charm. I found that the standard nuts will sometimes loosen after a run (since the TLR wheel barely leaves enough threads on the axle for the nylon to engage fully), I did not want to risk losing a wheel during a race.