Thank you very much for the reply, very helpful. So I think my first step is to properly run the truck, with my setup, just checking temps, then gear accordingly. Hopefully, the 25c packs will be enough.

How could one go about figuring out what amps a motor will draw?

Also, if I am to go up to a 3s, which I won't, but just for knowledge sake, would the amps go up or down?

I might be way off, but I heard the 1410 has an amp draw of 160A, and with my calculation, my battery's will only be able to supply 75A, is this correct or am I wrong?

Cheers
Ramon