One thing I've noticed is that....
sure people don't mind if a question has been asked before but if it doesn't get answered in the first page or two that it's posted in it usually gets passed over.
Anyway my question is. Are the dogbones supposed to be such a sloppy side to side fit in the outdrives? I've noticed about 1/2 mm movement side to side which is the cause of the rattle in the drive train.
BUT when I put in spacers on either side of the dogbone pins (made of 1/4 mm segments of 14 gauge wire insulation) to take out this free play I also lose overall drive train free wheeling spin.