R/C Tech Forums - View Single Post - Team Associated TC6 Thread

02-23-2012 | 08:36 AM

#5896

Rick Hohwart

Tech Elite

Joined: Sep 2003

Posts: 4,004

Quote:

Originally Posted by Steve S

Hey guys, I was going to try out Rick Hohwart's 11/01/2011 setup:

http://www.teamassociated.com/pdf/ca...ub_11-2011.pdf

I ran into a problem where the blades bottom out in the front diff outdrives. I have no idea if this was a problem in my previous setup and I just didn't notice until now, but is there some trick to this particular setup or have I screwed something up? I understand some people are running different universals, is that the difference?

Thanks!

Quote:

Originally Posted by grippgoat

The setup says 1mm on the arm mounts in front.... Typically I think that would mean 1mm non-offset, which maybe would cause a problem? Maybe it's supposed to mean 1mm offset since it's a 6.1 setup?

-mike

This setup did not list the mounts as offset which they are. Use the offset mounts or add 2mm shims to the standard mounts to get the correct width.

Quote:

Originally Posted by mtaddei

Anybody can help me?????

Nobody uses 2 deg caster. At least I have never heard of it. Is there a reason you must use this?

You can try this but it is not 2 degree caster.

Quote:

Originally Posted by ahpeq_ong

any news from Thailand ( TITC ) for AE driver..?

I have only seen a control practice time sheet which showed Juho and Keven somewhere between 10 and 20. There is a TITC 2012 Facebook page with some photos.

Reply