Originally posted by Trevor
Just check the usual thing in that the bearing is seated on the input gear and the gear is seated on the shaft properly. I've put graphite gears in and I didn't have to change the shimming. I've got about 0.75mm of backlash on the front with a one-way, running mod. Also make sure the bearing is sitting properly in its recess.
yup, just push that bearing in as hard as you can! you should still be able to acess the pin hole even with shims... your bearing's probably not seated completely!
0.75mm? wow, that's quite a lot of play... no broken spurs problems? (especially with a one way...)
later
Paul