R/C Tech Forums - View Single Post - Xray T3 2012
Thread: Xray T3 2012
View Single Post
Old 02-11-2012, 09:34 PM
  #1452  
smith9turbo
Tech Addict
 
smith9turbo's Avatar
 
Join Date: Aug 2011
Location: Thailand
Posts: 540
Default

Originally Posted by HarryLeach
Yeah, I tried all that too, degreasing all the parts, thread locker on the grub screw, still had a couple DNF's and wrecked hubs from the pin moving.

For $10, a year ago, I have no more issues.
oh, i forgot to tell about CVD hex screw
for T3 2010 this hex screw 3x2.5mm is the weak point. it's low material. (other hex screw size in the T3 2010 box is good material)
for T3 2012, i see 3x2.5 CVD hex screw is good material already.

T3 2010, CVD hex screw, look no good enough, since it is new.


T3 2010, CVD hex screw after run 8 packs.
seem screw's metal not hard enough. it easy to erode.


So, for my T3 2010 ... i must change to use tamiya hex screw 3x3mm instead. it work perfect for my over 1 year used.
but for my T3 2012 i still use CVD hex screw that is in T3 2012 KIT box. i think ... it good enough.

Last edited by smith9turbo; 02-11-2012 at 09:46 PM.
smith9turbo is offline