R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 02-03-2012 | 12:51 PM
  #10872  
Wild Cherry's Avatar
Wild Cherry
Tech Legend
 
Joined: Aug 2001
Posts: 22,595
From: TRCR Modified Driver
Default
Originally Posted by bshookup
Sorry if this has been covered already. I did some searching and couldn't find anything.

Last night I replaced a bad bearing and all of the gears in my gearbox and the gearbox is tight (doesn't spin freely) and it gets tighter the more I tighten the screws. This has happened to me before and I can't figure out the rhyme or reason. Does anyone have any experience solving this issue. Thanks in advance.

Way tight transmission screws ?

Suggest adding one 3/16th axle shim in ft of top shaft spacer....( not for spacing , better for bearing to ride on)

Also use the servo kit washers, not the metal .030 washer
transmission screw's...

*Lock Tight


note:
If transmission case is well used & screw's were way tight , it is now mostly warped & needs replacement .
Last edited by Wild Cherry; 02-03-2012 at 01:02 PM.
Wild Cherry is offline  
Reply