Originally Posted by
SuperRC
Hi all,
Im running a B44.1. I have configured it with the standard setup from the manual. With reference to the rear ride height, standard is 21mm. Now, the rear shock collars should be set at 1.7mm. This does not give me a rear ride height of 21mm. Particularly when I install the saddle pack lipos. The car is running rear end low.
At the moment I have the collars sitting at 8mm. Much more then what the manual states.
Does anyone have the same issue? How have you set your shock collars?
8 seems a bit high, but that is for an inside hole on the arm setup so you may be in the outside hole?
And those are just refs, use your ride height readings as the reading, but it should be to flat part of chassis without the undertray to make that measurement