Thread: STS engines
View Single Post
Old 08-03-2004, 06:52 PM   #1070
Z00M
Tech Master
 
Z00M's Avatar
 
Join Date: Jun 2004
Location: Perth, Western Australia
Posts: 1,173
Trader Rating: 15 (100%+)
Default

Dino,

Can you advise if the induction port height is supposed to be uneven on one side? I noticed that the port height is uneven and decided to measure with my calipers.

One of the induction ports is .2mm higher near the boost port than it is near the exhaust port. Other induction port is the same height across the port.

Can you explain if this is correct or just manufacturing tolerance?
__________________
My blog: http://mikesrc.wordpress.com
XRAY XB4
## NOSRAM ## XRAY ## KO ##
www.nbhc.com.au - www.teamxray.com
Z00M is offline   Reply With Quote