Hey everyone,
I replaced my CVAs today as the right hand side pair looked like boomerangs. But low and behold after a small session at my mates track this afternoon, my brand new rear right CVA was slightly bent.
With my powers of observation, I can see that where the sway bar passes over my rear CVAs, there are scuff marks, and it seems this is the origin of the bend.
Is it safe to assume that when landing a somewhat large table top jump, my CVAs are smacking the sway bars and bending? And only on the right side cause of stick pack configuration?
I've never used limiters before as I'm new to RC, are they the solution? If so are they the c shape clips that came with the kit? And how are they installed? Very noobish of me, but I appreciate your help.
Cheers.
Smithy